MagTag - 2.9" Grayscale E-Ink WiFi Display specs, pinout & datasheets
Imported entry: generated from open-source board definitions (circuitpython), not reviewed by a person. Each fact links to the definition it came from.
Can I still use it?
- CircuitPython
- Supported[1]
As published by each project, checked weekly. A platform not listed has no published information here, which is not the same as no support.
Pinout
Pin names in firmware (24 pins)
| Chip pin | Board names |
|---|---|
| GPIO0 | BOOT0 |
| GPIO1 | NEOPIXEL, D1 |
| GPIO3 | LIGHT, A3 |
| GPIO4 | VOLTAGE_MONITOR, BATTERY |
| GPIO5 | EPD_BUSY |
| GPIO6 | EPD_RESET |
| GPIO7 | EPD_DC |
| GPIO8 | EPD_CS |
| GPIO9 | ACCELEROMETER_INTERRUPT |
| GPIO10 | D10 |
| GPIO11 | BUTTON_D, D11 |
| GPIO12 | BUTTON_C, D12 |
| GPIO13 | LED, D13 |
| GPIO14 | BUTTON_B, D14 |
| GPIO15 | BUTTON_A, D15 |
| GPIO16 | SPEAKER_ENABLE |
| GPIO17 | SPEAKER |
| GPIO18 | A1, AD1 |
| GPIO21 | NEOPIXEL_POWER_INVERTED, NEOPIXEL_POWER |
| GPIO33 | SDA |
| GPIO34 | SCL |
| GPIO35 | EPD_MOSI |
| GPIO36 | EPD_SCK |
| GPIO37 | EPD_MISO |
Sources
Spotted a mistake?
Every report is read by a person and checked against a source before anything changes. Please link one if you have it.