DynaLoRa-USB specs, pinout & datasheets
Imported entry: generated from open-source board definitions (circuitpython), not reviewed by a person. Each fact links to the definition it came from.
Can I still use it?
- CircuitPython
- Supported[1]
As published by each project, checked weekly. A platform not listed has no published information here, which is not the same as no support.
Pinout
Pin names in firmware (15 pins)
| Chip pin | Board names |
|---|---|
| PA00 | D0, A0, SDA, TX, MOSI1 |
| PA01 | D1, A1, SCL, RX, SCK1 |
| PA02 | D2, A2, MISO1 |
| PA03 | SD_CS |
| PA09 | RADIO_INT |
| PA10 | RADIO_RESET |
| PA11 | RADIO_CS |
| PA15 | BUTTON |
| PA16 | MOSI |
| PA17 | SCK |
| PA18 | MISO |
| PA19 | NEOPIXEL |
| PA27 | LED |
| PA30 | D3 |
| PA31 | D4 |
Sources
Spotted a mistake?
Every report is read by a person and checked against a source before anything changes. Please link one if you have it.