Wireless Sensor Core WSC-1450 specs, pinout & datasheets
Imported entry: generated from open-source board definitions (circuitpython), not reviewed by a person. Each fact links to the definition it came from.
Can I still use it?
- CircuitPython
- Supported[1]
As published by each project, checked weekly. A platform not listed has no published information here, which is not the same as no support.
Pinout
Pin names in firmware (48 pins)
| Chip pin | Board names |
|---|---|
| P0_00 | 32KHZ_XTAL1 |
| P0_01 | 32KHZ_XTAL2 |
| P0_02 | BATTERY |
| P0_03 | BOARD_ID |
| P0_04 | INT_LIGHT_TOF |
| P0_05 | LED_RED |
| P0_06 | I2S_SCK |
| P0_07 | LORA_SCLK |
| P0_08 | I2S_WS |
| P0_09 | NFC1 |
| P0_10 | NFC2 |
| P0_11 | LORA_MOSI |
| P0_12 | LORA_MISO |
| P0_13 | DEBUG_TX |
| P0_14 | CELL_RTS |
| P0_15 | CELL_DCD |
| P0_16 | DEBUG_RX |
| P0_17 | QSPI_CSN |
| P0_18 | BT840_RESETN |
| P0_19 | QSPI_CLK |
| P0_20 | QSPI_IO0 |
| P0_21 | QSPI_IO1 |
| P0_22 | QSPI_IO2 |
| P0_23 | QSPI_IO3 |
| P0_24 | CELL_HW_SHUTDOWN |
| P0_25 | I2S_SD |
| P0_26 | SDA |
| P0_27 | SCL |
| P0_28 | CELL_POWER_ENABLE |
| P0_29 | PUSH_BUTTON |
| P0_30 | CELL_ON_OFF |
| P0_31 | SENSOR_POWER_ENABLE |
| P1_00 | BT840_SWO |
| P1_01 | CELL_RX |
| P1_02 | CELL_TX |
| P1_03 | CELL_DSR |
| P1_04 | CELL_DTR |
| P1_05 | INT_ACCEL |
| P1_06 | BOARD_ID_DISABLE |
| P1_07 | LORA_DIO0 |
| P1_08 | CELL_CTS |
| P1_09 | LORA_SSN |
| P1_10 | LORA_RESETN |
| P1_11 | BATTERY_MONITOR_ENABLE |
| P1_12 | LORA_DIO1 |
| P1_13 | LORA_DIO2 |
| P1_14 | LORA_DIO3 |
| P1_15 | CELL_PWRMON, LORA_DIO4 |
Sources
Spotted a mistake?
Every report is read by a person and checked against a source before anything changes. Please link one if you have it.