MicroMod nRF52840 Processor specs, pinout & datasheets
Imported entry: generated from open-source board definitions (circuitpython), not reviewed by a person. Each fact links to the definition it came from.
Can I still use it?
- CircuitPython
- Supported[1]
As published by each project, checked weekly. A platform not listed has no published information here, which is not the same as no support.
Pinout
Pin names in firmware (45 pins)
| Chip pin | Board names |
|---|---|
| P0_02 | SPI_CIPO, SPI_MISO, CIPO, MISO |
| P0_03 | G1, BUS1 |
| P0_04 | A1 |
| P0_05 | A0 |
| P0_06 | PWM0 |
| P0_07 | BOOT |
| P0_08 | I2C_SDA, SDA |
| P0_09 | G9, ADC_DM, CAM_HSYNC |
| P0_10 | G10, ADC_DP, CAM_VSYNC |
| P0_11 | I2C_SCL, SCL |
| P0_13 | LED |
| P0_14 | SDIO_CMD, SPI_COPI1, SPI_MOSI1 |
| P0_15 | I2C_INT |
| P0_16 | PWM1 |
| P0_17 | G5, BUS5 |
| P0_18 | RESET |
| P0_19 | SDIO_CLK, SPI_SCK1 |
| P0_20 | SPI_CS, CS |
| P0_21 | SDIO_DATA0, SPI_CIPO1, SPI_MISO1 |
| P0_22 | SDIO_DATA1 |
| P0_23 | SDIO_DATA2 |
| P0_24 | I2C_SCL1 |
| P0_25 | AUD_BCLK, I2S_SCK, PCM_CLK, PDM_CLK |
| P0_26 | AUD_LRCLK, I2S_WS, PCM_SYNC, PDM_DATA |
| P0_27 | D0 |
| P0_28 | SPI_SCK, SCK, LED_CLK |
| P0_29 | G0, BUS0 |
| P0_30 | BATT_VIN3 |
| P0_31 | SPI_COPI, SPI_MOSI, COPI, MOSI, LED_DAT |
| P1_00 | SDIO_DATA3, SPI_CS1 |
| P1_01 | I2C_SDA1 |
| P1_02 | UART_RTS1 |
| P1_03 | UART_TX1, TX |
| P1_04 | G7, BUS7 |
| P1_05 | UART_RX2 |
| P1_06 | G6, BUS6 |
| P1_07 | UART_TX2 |
| P1_08 | D1, CAM_TRIG |
| P1_09 | UART_CTS1 |
| P1_10 | UART_RX1, RX |
| P1_11 | G4, BUS4 |
| P1_12 | G3, BUS3 |
| P1_13 | G2, BUS2 |
| P1_14 | G8 |
| P1_15 | P3V3_EN |
Sources
Spotted a mistake?
Every report is read by a person and checked against a source before anything changes. Please link one if you have it.