Cytron Maker Feather AIoT S3 specs, pinout & datasheets
- Chip / SoC
- ESP32-S3
- Clock
- 240 MHz
Imported entry: generated from open-source board definitions (platformio, circuitpython), not reviewed by a person. Each fact links to the definition it came from.
Specifications
Upload limits are what a sketch or firmware may use after the bootloader, as the build tools enforce them, not the chip’s full memory.
Can I still use it?
- Arduino framework
- Supported[1]Arduino framework available through PlatformIO.
- CircuitPython
- Supported[2]
As published by each project, checked weekly. A platform not listed has no published information here, which is not the same as no support.
Datasheets and documents
Pinout
Pin names in firmware (27 pins)
| Chip pin | Board names |
|---|---|
| GPIO0 | BOOT, BOOT0, D0 |
| GPIO2 | LED, L, LED_BUILTIN, D2 |
| GPIO3 | BUTTON, D3 |
| GPIO4 | A4, T4, D4 |
| GPIO5 | A3, T5, D5 |
| GPIO6 | A2, T6, D6 |
| GPIO7 | SS, A5, T7, D7 |
| GPIO8 | MOSI, A7, T8, D8 |
| GPIO9 | A1, T9, D9 |
| GPIO10 | A0, T10, D10 |
| GPIO11 | VP_EN, D11 |
| GPIO12 | BUZZER, D12 |
| GPIO13 | VIN, VBATT, VOLTAGE_MONITOR, A12, D13 |
| GPIO14 | A11, T14, D14 |
| GPIO15 | TX, A10, D15 |
| GPIO16 | RX, A9, D16 |
| GPIO17 | SCK, A6, D17 |
| GPIO18 | MISO, A8, D18 |
| GPIO21 | D21 |
| GPIO38 | D38 |
| GPIO39 | D39 |
| GPIO40 | D40 |
| GPIO41 | SCL, D41 |
| GPIO42 | SDA, D42 |
| GPIO46 | RGB, RGB_BUILTIN, NEOPIXEL, D46 |
| GPIO47 | D47 |
| GPIO48 | D48 |
Sources
Spotted a mistake?
Every report is read by a person and checked against a source before anything changes. Please link one if you have it.