LilyGo T-Display-S3 specs, pinout & datasheets
- Chip / SoC
- ESP32-S3
- Clock
- 240 MHz
Imported entry: generated from open-source board definitions (platformio, circuitpython), not reviewed by a person. Each fact links to the definition it came from.
Specifications
Upload limits are what a sketch or firmware may use after the bootloader, as the build tools enforce them, not the chip’s full memory.
Can I still use it?
- Arduino framework
- Supported[1]Arduino framework available through PlatformIO.
- CircuitPython
- Supported[2]
As published by each project, checked weekly. A platform not listed has no published information here, which is not the same as no support.
Datasheets and documents
Pinout
Pin names in firmware (31 pins)
| Chip pin | Board names |
|---|---|
| GPIO0 | BUTTON0, IO0 |
| GPIO1 | IO1 |
| GPIO2 | IO2 |
| GPIO3 | IO3 |
| GPIO4 | BATTERY |
| GPIO5 | LCD_RST |
| GPIO6 | LCD_CS |
| GPIO7 | LCD_DC |
| GPIO8 | LCD_WR |
| GPIO9 | LCD_RD |
| GPIO10 | IO10 |
| GPIO11 | IO11 |
| GPIO12 | IO12 |
| GPIO13 | IO13 |
| GPIO14 | BUTTON1, IO14 |
| GPIO15 | LCD_POWER_ON |
| GPIO16 | IO16, TOUCH_INT |
| GPIO17 | IO17, TOUCH_SCL |
| GPIO18 | IO18, TOUCH_SDA |
| GPIO21 | IO21, TOUCH_RES |
| GPIO38 | LCD_BCKL |
| GPIO39 | LCD_D0 |
| GPIO40 | LCD_D1 |
| GPIO41 | LCD_D2 |
| GPIO42 | LCD_D3 |
| GPIO43 | IO43, STEMMA_SDA |
| GPIO44 | IO44, STEMMA_SCL |
| GPIO45 | LCD_D4 |
| GPIO46 | LCD_D5 |
| GPIO47 | LCD_D6 |
| GPIO48 | LCD_D7 |
Sources
Spotted a mistake?
Every report is read by a person and checked against a source before anything changes. Please link one if you have it.