MaTouch ESP32-S3 Parallel TFT with Touch 7“ specs, pinout & datasheets
Imported entry: generated from open-source board definitions (circuitpython), not reviewed by a person. Each fact links to the definition it came from.
Can I still use it?
- CircuitPython
- Supported[1]
As published by each project, checked weekly. A platform not listed has no published information here, which is not the same as no support.
Pinout
Pin names in firmware (17 pins)
| Chip pin | Board names |
|---|---|
| GPIO1 | BUTTON |
| GPIO2 | I2S_WORD_SELECT |
| GPIO10 | TFT_BACKLIGHT |
| GPIO11 | SDIO_CMD |
| GPIO12 | SDIO_CLK |
| GPIO13 | SDIO_D0 |
| GPIO17 | SDA |
| GPIO18 | SCL |
| GPIO19 | GPIO19, I2S_DATA |
| GPIO20 | GPIO20, I2S_BIT_CLOCK |
| GPIO38 | TOUCH_RESET |
| GPIO39 | hsync |
| GPIO40 | de |
| GPIO41 | vsync |
| GPIO42 | dclk |
| GPIO43 | TX |
| GPIO44 | RX |
Sources
Spotted a mistake?
Every report is read by a person and checked against a source before anything changes. Please link one if you have it.