ThingPulse Pendrive S3 specs, pinout & datasheets
Imported entry: generated from open-source board definitions (circuitpython), not reviewed by a person. Each fact links to the definition it came from.
Can I still use it?
- CircuitPython
- Supported[1]
As published by each project, checked weekly. A platform not listed has no published information here, which is not the same as no support.
Pinout
Pin names in firmware (10 pins)
| Chip pin | Board names |
|---|---|
| GPIO0 | BUTTON, BOOT0, D0 |
| GPIO1 | D1, TouchIn |
| GPIO5 | D5, NEOPIXEL |
| GPIO33 | D33 |
| GPIO34 | D34, CS |
| GPIO35 | D35, MISO |
| GPIO36 | D36, SCLK |
| GPIO37 | D37, MOSI |
| GPIO38 | D38 |
| GPIO39 | TX, D39 |
Sources
Spotted a mistake?
Every report is read by a person and checked against a source before anything changes. Please link one if you have it.