VINA-D51 (PCB 7) specs, pinout & datasheets
Imported entry: generated from open-source board definitions (circuitpython), not reviewed by a person. Each fact links to the definition it came from.
Can I still use it?
- CircuitPython
- Supported[1]
As published by each project, checked weekly. A platform not listed has no published information here, which is not the same as no support.
Pinout
Pin names in firmware (61 pins)
| Chip pin | Board names |
|---|---|
| PA02 | DAC0 |
| PA04 | A0 |
| PA05 | DAC1 |
| PA06 | A1 |
| PA07 | A2 |
| PA12 | ESP01_RX, UART3_RX, I2C3_SCL, E2 |
| PA13 | ESP01_TX, UART3_TX, I2C3_SDA, E1 |
| PA14 | D11 |
| PA15 | D12 |
| PA16 | I2C1_SCL, SCL |
| PA17 | I2C1_SDA, SDA |
| PA18 | ESP01_GPIO0, E3 |
| PA19 | ESP01_GPIO2, E4 |
| PA20 | I2S_FS_0 |
| PA21 | I2S_SDO |
| PA22 | I2S_SDI |
| PA23 | LED_B, LED_STATUS |
| PB00 | RS485_TE |
| PB01 | RS485_RE |
| PB02 | RS485_TX |
| PB03 | RS485_RX |
| PB04 | A7 |
| PB05 | A8 |
| PB06 | A9 |
| PB07 | A10 |
| PB08 | A3 |
| PB09 | A4 |
| PB12 | D13 |
| PB13 | D14 |
| PB14 | LED_R |
| PB15 | LED_G |
| PB16 | I2S_SCK_0 |
| PB17 | I2S_MCK_0 |
| PB18 | D7 |
| PB19 | D8 |
| PB20 | UART2_RX, RX, I2C2_SCL |
| PB21 | UART2_TX, TX, I2C2_SDA |
| PB22 | SPI_SS, SS |
| PB23 | SPI_MISO, MISO |
| PB24 | UART1_RX |
| PB25 | UART1_TX |
| PB31 | D0 |
| PC00 | A11 |
| PC02 | A5 |
| PC03 | A6 |
| PC05 | LED_RX |
| PC06 | LED_TX |
| PC12 | D9 |
| PC13 | D10 |
| PC14 | ESP01_RESET, E6 |
| PC15 | ESP01_EN, E5 |
| PC16 | D1 |
| PC17 | D2 |
| PC18 | D3 |
| PC19 | D4 |
| PC20 | D5 |
| PC21 | D6 |
| PC24 | UART1_RTS |
| PC25 | UART1_CTS |
| PC27 | SPI_MOSI, MOSI |
| PC28 | SPI_SCK, SCK |
Sources
Spotted a mistake?
Every report is read by a person and checked against a source before anything changes. Please link one if you have it.